To use a compass, set your bearing on the rotating bezel, hold the compass flat in front of you with the direction-of-travel arrow pointing straight ahead, and turn your whole body until the red end of the needle sits inside the orienting arrow. This is called “Put Red in the Shed.” The direction-of-travel arrow now points where you need to go. Pick a landmark on that line, walk to it, and repeat.
Anatomy of a Baseplate Compass: Reading the Dial and Geometry
The baseplate (protractor) compass most hikers use was invented by the Kjellstrom brothers around the World War II era. The numbers on its dial divide the circle into 360 degrees, counted clockwise from north: east is 90, south 180, west 270.
A typical baseplate compass has these parts:
- Clear baseplate: A transparent rectangular base that lets you see the map underneath while aligning bearings.
- Rotating bezel (azimuth ring): A dial marked 0 to 360 degrees, typically in 2-degree increments on most baseplate compasses; some models click on each increment for low-light use.
- Magnetic needle: Floats inside the housing; its red end always points to magnetic north, and the white or black end points to magnetic south.
- Orienting arrow (“the shed”): A fixed arrow inside the bezel housing. Aligning the red needle inside it locks your compass to your bearing (“Put Red in the Shed”).
- Orienting lines (meridian lines): Lines inside the bezel that run parallel to the orienting arrow and help you align the compass with north-south grid lines on a map.
- Direction-of-travel arrow: A fixed arrow on the baseplate pointing away from your body toward your intended destination.
- Index line: A fixed reference mark located directly above the bezel where you read your current bearing in degrees.
- Rulers and map scales: Measurements printed along the straight edges in inches and centimeters to help measure map distances, often alongside map scales such as 1:24,000 and 1:62,500 (USGS), or 1:25,000 and 1:50,000.
- Lanyard hole: An attachment point for wearing the compass around the neck or attaching it to a pack to prevent loss and keep it accessible.
- Sighting mirror: An optional mirror that helps shoot more accurate bearings by allowing you to sight a landmark while simultaneously reading the needle.
How to Use a Compass on a Map: The Four-Step Bearing Sequence
A bearing is a direction expressed in degrees measured clockwise from north. For example, instead of traveling northwest, you follow a bearing of 315 degrees. When using a compass on a map, orienteers use a four-step sequence: Edge to target, box the grid, needle in the shed, then walk the direction-of-travel arrow.
- Edge to target: Lay the baseplate edge along the line from your position (Point A) to your destination (Point B), with the direction-of-travel arrow pointing from Point A toward Point B. If it points toward Point A, your bearing will be reversed by 180 degrees.
- Box the grid: Hold the baseplate firmly in place on the map. Turn the rotating bezel until the internal orienting lines run parallel to the map’s north-south grid lines, with the orienting arrow pointing toward the north of the map. Read the degree value aligned with the index line.
- Needle in the shed: Lift the compass off the map and hold it flat and away from your body, keeping the direction-of-travel arrow pointing straight ahead. Turn your entire body, not just the compass, until the red needle settles squarely inside the orienting arrow.
- Walk the direction-of-travel arrow: Look along the direction-of-travel arrow. Instead of staring at the needle with every step, pick a feature directly on your line, such as a specific tree, boulder, or bend in a stream, walk to it, and sight again. This leapfrog method prevents drift and keeps you on course.
Baseplate vs. Thumb Compass: Choosing the Right Tool
Whether a baseplate or a thumb compass suits you better depends on how fast you move and how you navigate. World championships have been won with both types.
| Feature | Baseplate (Protractor) Compass | Thumb Compass |
|---|---|---|
| Attachment Method | Held in palm or worn around the neck via lanyard | Straps directly to the thumb of the hand that holds the map |
| Map Alignment | Straight edge plots bearings on a map and measures distances | Compass tip anchors directly on your current map position |
| Dial Markings | Full 0–360° degree increments for precise bearing readings | Simplified or degree-free dial; aligns needle to map lines at speed |
| Hand Freedom | Requires two hands for steady plotting and manipulation | Frees the opposite hand for balance or climbing |
| Best Application | Beginners, kids, class sets, and hiking on large topo maps | Fast-paced competitive orienteering allowing quicker bearings |
For beginners, kids, and class sets, the baseplate compass is the better tool: it works in either hand, suits a whole group, and is easier for children to hold level. Skip models with a hinged sighting cover for orienteering, because there is rarely time to raise the compass to eye level. For hiking on large topographic maps, a baseplate compass is the better choice.
Orienting the Map in Ten Seconds
Orienting a map means turning it so that north on the sheet matches north in the real world. A ridge printed on the paper then lines up with the actual ridge in front of you. It takes about ten seconds and is the basic skill to learn before any bearing work, because it lets you match trail bends, ridges, and streams with what you see.
To orient your map using a baseplate compass, place the instrument on the map with the direction-of-travel arrow pointing toward the top of the sheet. Rotate the bezel so “N” lines up with the direction-of-travel arrow. Now rotate the map and compass together until the red needle settles directly inside the orienting arrow.
Without a compass, you can orient your map using terrain: identify two features you can see and also find on the map, such as a named summit and a lake, and rotate your map until both line up with the physical features.
Orienteering maps have one advantage over most topographic maps: they are drawn to magnetic north, not true north. So no declination correction is needed between the map and the compass needle.
How to Use a Compass Without a Map
Without a map, a compass tells you the cardinal directions and lets you follow a bearing, find north, walk a straight line, and retrace your route.
To establish a quick heading toward a distant destination without a map, point the direction-of-travel arrow at your target. Rotate the bezel until north on the bezel and the red needle align. Pick a landmark along that line and walk to it.
When you encounter an obstacle such as a pond or cliff, use the box method to skirt around it without losing your line:
- Stop at the obstacle, turn 90 degrees left, and walk a counted number of paces until you have cleared the obstacle edge.
- Turn 90 degrees right to resume your forward direction, and walk past the obstacle until it is behind you.
- Turn 90 degrees right again, and walk the exact same counted number of paces back to your original line.
- Turn 90 degrees left and resume your original bearing.
To retrace your steps or confirm you are on line, calculate a back bearing: add 180 degrees if your forward bearing is under 180 degrees, or subtract 180 degrees if it is over 180 degrees.
Magnetic Declination in the Pacific Northwest
Magnetic declination is the angle between true north (the geographic North Pole) and magnetic north (where the compass needle points). It is positive (east) when the needle points east of true north.
Along the agonic line, which runs roughly along 93 degrees west longitude through the central United States, declination is zero and a compass needle points directly toward true north. Across the continental United States, declination spans roughly 30 degrees, ranging from about 15 degrees west in Maine to about 15 degrees east in Washington State.
In the Pacific Northwest, declination is large, so it matters on every standard topographic map:
- Seattle area: about 14.9 degrees east, shrinking by about 0.12 degrees per year.
- Portland area: about 14.5 degrees east, shrinking by about 0.12 degrees per year.
- The drift factor: The North Magnetic Pole drifts about 55 kilometers (34 miles) per year. The current navigational standard is the World Magnetic Model 2025 (WMM2025), valid 2025–2030 and published jointly by NOAA NCEI and the British Geological Survey, updated every five years. Older printed maps can show declination values that are 1 to 3 degrees off, so check a current value before a trip.
In the Pacific Northwest, a single degree of uncorrected declination error sets you 100 feet (about 30 meters) off course per mile (1.6 kilometers) walked. With a 15-degree east uncorrected declination, you will miss your target by approximately 1,350 feet (410 meters) sideways after traveling just one mile.
To turn a map bearing (true north) into the compass bearing you walk in the Pacific Northwest, subtract the east declination: a map bearing of 90 degrees becomes about 75 degrees with 15 degrees east declination. To plot a compass bearing back onto the map, add the east declination. A common memory aid is “east is least, west is best.” Compasses equipped with a declination adjustment screw allow you to offset the orienting arrow once for your region, reading bearings straight off the map without manual arithmetic.
Advanced Techniques: Aiming Off and Field Drills
Aiming off (intentional error) is a technique used when approaching a control on a linear feature such as a stream, fence, or ridge: you deliberately aim to one side of your target so you know for certain which way to turn when you hit the linear feature.
Without aiming off, you hit the stream at an uncertain spot and have to guess left or right, with a 50 percent chance of making the error worse. A typical aiming-off offset is 10 degrees added or subtracted from the direct bearing; over longer distances a smaller offset suffices because the bearing can be walked more accurately. Aiming off works best when the catching feature is long, distinct, and runs at roughly right angles to your approach direction. Similarly, a collecting feature is a prominent linear feature along the route (such as a track or fence) that simplifies navigation by letting you follow it rather than merely crossing it.
You can build pacing consistency and compass handling using these field exercises:
- Pacing a square: Place a flag at the start, pick any bearing, and walk a known distance (such as 50 feet) by counting paces. Add 90 degrees to your bezel, walk that distance, and repeat this three more times. If your bearings and pacing are consistent, the fourth leg brings you back to your start flag.
- Backyard orienteering: Draw a simple map of your yard featuring objects such as trees, bushes, and buildings. Place control markers and practice navigating between them using compass bearings.
- Fog-O and Donut-O: Advanced training drills used in orienteering. In Fog-O (corridor orienteering), all map terrain is blocked out except for a narrow strip connecting the controls, requiring pure compass tracking. In Donut-O, the area immediately surrounding every control is blocked out, forcing you to navigate to an attack point before bearing into the control.
- Leapfrog exercise: Practice in pairs in open terrain. One partner stands still on the bearing line while the second walks forward until nearly out of sight. The stationary partner signals left or right until the walker is aligned, then the rear partner advances to that position and repeats the sequence.
Common Navigation Errors and Myths to Avoid
These are the mistakes that most often send people off course:
- The 180-degree reversal error: The orienteer aligns the compass north to south on the map and strides off in exactly the wrong direction. Prevent this by checking that the orienting arrow points to map north, not south.
- Magnetic interference from trail gear: A phone, knife, belt buckle, magnetic pack clip, or trekking pole magnet near the compass can deflect the needle by several degrees. Hold the compass in your fingers only, away from such gear.
- Walking while watching the needle: Staring at your dial while marching causes the needle to bounce with every step and leads to drift. Set your bearing, select an intermediate landmark in the terrain, and walk to that target.
- Parallel errors: Mistaking a similar terrain feature (such as two adjacent re-entrants) for the one marked on the map. Verify your position using a unique secondary feature to distinguish them before setting off.
- Over-running the map: Moving faster than you can navigate, losing contact with the map, and having to relocate from scratch. The rule is to run only as fast as you can safely read the terrain.
- Following the needle instead of the bearing: Navigators sometimes instinctively turn their compass to keep the needle aligned, which walks them north regardless of their desired course. Rotate your entire body rather than the bezel, and follow your direction-of-travel arrow.
- Starting from an uncertain position: Taking a bearing from an unverified location leads to “precise wandering.” Confirm your exact starting position with at least two matching terrain features before setting out.
Frequently Asked Questions
How do I use a compass to find direction?
Set the bezel to N (0 degrees), hold the compass level, and turn your body until the red needle sits inside the orienting arrow. The direction-of-travel arrow now points to magnetic north; south is behind you, east to your right, and west to your left.
How do you know which way is north on a compass?
When you hold the compass level, the floating needle settles and its red end always points toward magnetic north.
Do you read the red or white on a compass?
You always read the red end. The red tip is the north-seeking end of the magnetic needle that indicates magnetic north, while the white or black end points south.
How do I know which direction I’m going?
The direction-of-travel arrow on the baseplate shows where you are heading. To get it as a number, point that arrow ahead, turn the bezel until the red needle sits in the orienting arrow, and read the degrees at the index line.
What is the easiest way to remember compass directions?
The standard mnemonic for the four cardinal directions in clockwise order is “Never Eat Soggy Waffles” (North, East, South, West). To remember how to lock your needle during field navigation, use the phrase “Put Red in the Shed.”
